气动执行器的基本工作原理是什么？

The basic working principle of a pneumatic actuator can be summarized as follows: It utilizes the pressure energy of compressed air, converting

it into mechanical energy through an internal structure to drive valves or other mechanisms to complete linear or rotary motion.

Specifically, its working process includes the following key points:

Energy Conversion: The core is the conversion of compressed air pressure energy into mechanical energy. When compressed air enters the

actuator's air chamber, it generates pressure on the piston or diaphragm, pushing it to the side with lower pressure, thereby driving the push rod,

gear rack, and other transmission mechanisms to output force or torque.

Action Types: There are mainly two types.

Single-acting (Spring Return): Contains an internal spring. When compressed air drives the piston, the spring is compressed; when the air supply

is cut off or lost, the spring force automatically pushes the piston back to its original position. This design allows it to automatically return to a

preset safe position (normally open or normally closed) in case of air supply failure.

Double-acting: Has no internal spring. Movement in both directions is achieved by alternately supplying air to both sides of the cylinder. When air

enters from one side, the piston moves to the other side; when air enters from the opposite side, it returns to its original position. This type

offers greater thrust and maintains a stable position, but it cannot automatically reset after air supply interruption.

Motion Modes: Depending on the valve type, pneumatic actuators output two types of motion.

Linear Stroke: Outputs linear reciprocating motion, commonly used to drive single-seat valves, regulating valves, etc. Common structures are

diaphragm type (suitable for small thrust, high-precision regulation) and piston type (suitable for large thrust).

Angular Stroke: Outputs rotary motion from 0° to 90° (or larger angles), commonly used to drive ball valves, butterfly valves, plug valves, etc.

Common structures are rack and pinion type and fork type.

Control and Positioning: For precise control, it is usually used in conjunction with a solenoid valve (to control air supply on/off) and a valve

positioner. The positioner receives a 4-20mA electrical signal from the control system and adjusts the air intake to precisely match the valve opening with the input signal, thereby achieving continuous proportional regulation.

In general, pneumatic actuators use compressed air as power and are characterized by simple structure, fast response speed, good

explosion-proof performance (no sparks), and large thrust/torque. Therefore, they are widely used in industrial automation fields such as

petroleum, chemical, and power, where explosion-proof and reliability requirements are high.